Nikon 58-104 Manuel d'utilisateur télécharger pdf (Page 49)

I Turn ON the SB-104’s power switch,

• and check to be sure that the ready-

light is lit.

The shutter is released each time

' another speedlight fires, and the

SB-104 mounted on the camera also

fires at the preset mode.

• Caution

If there are other people in the area firing a speedlight, it may cause

your Speedlight to fire also.

♦Notes

♦It is recommended that you use a tripod for this operation unless you

have someone to assist by holding the slave SB-104 and Nikonos RS.

♦Underwater Camera Slave (cordless remote photography) when

another speedlight (activating a shutter release operation) and the

SB-104 are facing each other is possible within a distance of 10 meters

(32.8 feet).

♦If the flash from the other speedlight (activating shutter release

operation) is not detected by the sensor on the SB-104, the SB-104 may

not fire. Check to be sure the flash fires properly before using it.

♦Battery power consumption of the SB-104 when set for cordless remote

operation is as follows:

With standby switch ON: Equivalent power required for one manual full

output is consumed in approximately six hours.

With standby switch OFF: Equivalent power required for one manual

full output is consumed in approximately 10 minutes.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 71 72

Pas de commentaire

Nikon 58-104 Manuel d'utilisateur Page 49