Nikon 58-104 Manuel d'utilisateur télécharger pdf (Page 21)

Function Selector

. GJ ffl ffl

• o o

The Function Selector is used in the ways described below.

^3 standard flash photography

standard flash photography is possible

except for the following modes.

The following functions are also possible

by sliding the selector from ^ to [5 .

^ Test firing

The SB-104’s fiash can be tested.

—Useful for test firing the flash before taking pictures.

Signai Flash

When the function seiector is held in the test firing position for more than

four seconds, it will begin firing a signal flash at 1/32 power approximately

every two seconds.

—This is convenient when you are on the surface and wish to signal your location

in the water to orhers.

(Q) Camera Slave (cordless remote photography)

When set to “Camera Slave”, the SB-104’s built-in slave sensor can detect

the flash of another Speedlight, and as it flashes the SB-104 will signal the

Nikonos RS to release its shutter simultaneously, exposing the frame.

Cordless remote photography can be performed with another Speedlight

that can be flashed.

—It is effective up to a distance of 10 meters (32.8 feet) and can be performed only

with the Nikonos RS.

(5] Flash Slave

The SB-104 can be fired simultaneously with other Speedlights (SB-104,

SB-101, SB-102 or SB-103) mounted on the Nikonos RS, V, or IV-A when its

built-in slave sensor detects the flash of other Speedlights.

—This is useful when you want to add more light to your scene or when you wish

creative photographic lighting. When the SB-104 is set to “Fiash Slave”, it acts

as a second light source for another primary camera and Speedlight.

I Important

Be sure to turn OFF the power before switching among ,

positions.

and (5

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 71 72

Pas de commentaire

Nikon 58-104 Manuel d'utilisateur Page 21