Nikon 58-104 Manuel d'utilisateur télécharger pdf (Page 35)

Be sure that all water has been removed...

Several days are required for all water to dry from below the rubber cover.

Keep In mind that water may still remain in hard-to-reach areas even after

the surface has dried.

Disconnect the sync cord from the

socket and attach the cap...

Salt and other foreign matter will remain on

the sync cord and the socket if the cord is

not disconnected. After washing and drying

the Speedlight, remove the plug and

remove all the salt. After that, it is a good

idea to apply a small amount of 0-ring

lubricant to the screw threads. Be sure

always to attach the socket cap to prevent

water or dirt from getting into the socket.

Also dry the battery chamber...

After drying the main body, open the

battery chamber, remove the battery, and

let the inside of the chamber dry

completely before closing it again.

If switch or selector movements become

rough...

Tiny particles of sand getting inside the

panel may affect smooth operation of the

power switch or selector. In this event,

remove the four screws (as illustrated),

open the panel, and rinse out the sand.

Reassemble the panel after letting the

inside dry completely. If a screw is lost,

use a spare screw provided.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 71 72

Pas de commentaire

Nikon 58-104 Manuel d'utilisateur Page 35