Nikon SB-400 Manuel d'utilisateur télécharger pdf (Page 13)

Install the batteries following

the i and j marks as

shown. Then close the

battery chamber lid by

sliding it into place while

pressing down.

Usable batteries

Install two AA-type penlight batteries (1.5 V or lower) of any of these types:

Alkaline-manganese (1.5 V), Lithium (1.5 V), Oxyride (1.5 V), Ni-MH

[Nickel Metal Hydride (rechargeable), (1.2 V)]

• When replacing batteries, replace both with fresh ones of the same brand.

• Carbon-zinc batteries are not recommended for use with the SB-400.

• Depending on battery specifications, when the Lithium batteries become hot, the

safety circuits are activated, cutting off power. This often occurs when the flash

unit is operated in the repeating flash mode. Battery power will recover when the

temperature returns to normal.

Replacing/recharging the batteries

When the battery power becomes low, the Ready-light blinks at 2 Hz

(twice in a second) for approx. 40 seconds. Replace or recharge batteries.

Standby function to conserve battery power

• If the SB-400 and the camera are not used for more than 40 seconds, the standby

function activates and automatically turns the SB-400 off to conserve battery

power (it goes into the standby mode).

• When the SB-400 is mounted on a camera, the SB-400 automatically turns off

when the camera goes into standby mode after the camera’s exposure meter is

switched off.

• When in the standby mode, the SB-400 turns back on again when the [ON/OFF]

switch is [ON], or the camera's shutter release button is lightly pressed.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 219 220

Pas de commentaire

Nikon SB-400 Manuel d'utilisateur Page 13