Nikon SB-800 Manuel d'utilisateur télécharger pdf (Page 58)

Checking the correct exposure before shooting

You can determine whether the subject will receive the correct exposure by

test firing the SB-800 before actually taking the picture in TTL auto flash, Auto

Aperture, and Non-TTL auto flash operations.

• In manual flash mode, checking the correct exposure cannot be performed by

test firing.

■

TTL auto flash mode

Press the SB-800’s a button until B (Auto Aperture flash) or A (Non-

TTL auto flash) appears on the LCD panel. Set the same aperture on the

SB-800 as set in the TTL auto flash mode. Press the shutter release button

slightly, then press the FLASH button to fire the flash. If the ready-light blinks

after firing, this indicates the light may have been insufficient for correct

exposure. In this case, set a wider aperture on the camera or lens, or move

closer to the subject.

■

Auto Aperture flash

Make the necessary settings on the SB-800 and camera, press the shutter

release button slightly, then press the FLASH button to fire the flash. If the

ready-light blinks after firing, this indicates the light may have been insufficient

for correct exposure. In this case, set a wider aperture on the camera or lens,

or move closer to the subject.

■

Non-TTL auto flash

Make the necessary settings on the SB-800 and camera, then press the

FLASH button to fire the flash. If the ready-light blinks after firing, this indicates

the light may have been insufficient for correct exposure. In this case, set a

wider aperture on the camera or lens, or move closer to the subject.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 131 132

Pas de commentaire

Nikon SB-800 Manuel d'utilisateur Page 58