Nikon CAPTURE NX2 Manuel d'utilisateur télécharger pdf (Page 94)

92 Chapter 13 — The Toolbar | Straighten Tool

To straighten your image using the straighten tool, follow these steps:

With an image open within the editor, click the straighten tool in the toolbar.

Locate a line within the image that should be either

vertical or horizontal and click on the start of the

line. Holding the mouse button down, draw the

entire length of the line, letting go when you have

reached the end of that line. The straighten tool will

then calculate the direction and degree of the

rotation to apply to the image to make the line you

described either horizontal or vertical.

If you made a mistake while drawing the line, you can click on the line you added to the image and

adjust one of the two anchor points found at either end of the line, or you can re-draw the line by

clicking and dragging within the image window again.

By default, Capture NX 2 will automatically crop the

image using the same aspect ratio to hide all areas of

the image where there is no image information.

These areas that lack information are created when

the image is rotated, and are represented by pure

white pixels. To prevent Capture NX 2 from

automatically cropping the image, check the

Include areas without image data option in the

Straighten step of the Edit List palette.

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 267 268

Pas de commentaire

Nikon CAPTURE NX2 Manuel d'utilisateur Page 94