Nikon WIRELESS KEYPAD KIT HMSC7075 Manuel d'utilisateur télécharger pdf (Page 6)

Troubleshooting

Problem Solution

Module will not register

with the Wireless System

Controller

• Ensure that the module's AC adapter is plugged in or has fresh batteries.

• Ensure that the Wireless System Controller is powered and online.

• Ensure that you are pressing the Discovery button.

• Reposition the module closer to the Wireless System Controller.

• Try another location.

The Wireless System

Controller does not

recognize the module

during discovery mode

Make sure your Wireless System Controller indicates discovery mode and that the

module is powered with fresh batteries. Press the Discovery button found inside of the

battery compartment. If this continues to fail, you will need to try another location for

the module. You may also try a hard reset by holding down the Discovery button while

powering on the module. After resetting the module, please try to discover it again.

The status LED turns red

when I touch the key to

the Keypad port.

The key was not accepted by the system. Try registering the key again.

Features and Specifications

• Device signal communication

• LED in module illuminates when activity occurs

• Home and Away LEDs light when either is activated

• Weather resistant

• Hardware and base provided for either wall or table mounting

• AC power adapter included

Communication frequency: 418 MHz

Typical range outdoors: 200 feet (60 m)

Typical range indoors: 60 feet (18 m)

Dimensions: 3.94"L × 2.32"W × 1.10"H (100mm × 59mm × 28mm)

Operational temperature/ humidity: 32° to 104° F with 10% to 80% humidity with all components operating within

manufacturer thermal limits

Storage temperature: -25° C to 75° C

1 2 3 4 5 6 7 8 9

Pas de commentaire

Nikon WIRELESS KEYPAD KIT HMSC7075 Manuel d'utilisateur Page 6