Nikon SB-30 Manuel d'utilisateur télécharger pdf (Page 23)

Two methods of wireless slave flash shooting

Wireless slave flash can be performed in two ways by setting the Mode

selector dial:

(1) Auto wireless slave flash (A) mode:

• The SB-30 starts and stops firing in sync with the master Speedlight.

• The maximum shooting distance of the SB-30’s light sensor is approx. 5m (16 ft.).

(2) Manual wireless slave flash (M) mode:

• The SB-30 only fires at M1/1 output in sync with the master Speedlight.

• The maximum shooting distance of the SB-30’s light sensor is approx. 40m (131 ft.).

Notes

• Position the slave flash unit (SB-30) so that light from the master flash unit can reach the light sensor of the

slave flash unit. This is particularly important when taking pictures while holding a slave flash unit in your hand.

•

The correct exposure cannot be obtained if the master Speedlight fires a series of preflashes (Monitor Preflash).

Cancel the Monitor Preflash of the master flash unit using the methods described below. This is necessary

except for the one preliminary flash firing of the COOLPIX that does not affect the correct exposure.

Basic operation

F80-Series/N80-Series, Set the camera’s exposure mode to Manual (M)

F70-Series/N70

F5, F100, F90X/N90s, Cancel the Monitor Preflash of the Speedlight mounted on the camera.

F90-Series/N90

D1-Series Set the flash mode of the Speedlight mounted on the camera to Non-TTL auto

or Manual flash.

SB-30 -E 01.08 2002.12.26 17:23 ページ2 1

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 138 139

Pas de commentaire

Nikon SB-30 Manuel d'utilisateur Page 23