Nikon 5000 ED Manuel d'utilisateur télécharger pdf (Page 33)

Step 1 — Turn the Scanner On

Before turning on the scanner for the ﬁ rst time, make sure that Nikon Scan is installed on the

computer and that the power and USB cables are connected. For information on installing

Nikon Scan and connecting the cables, see “Setup” (

7).

Turn the computer on

Turn the computer on and wait for the operating system to start up.

Turn the scanner on

The status LED will blink for about 30 seconds (5000 ED) or 20 seconds (COOLSCAN V

ED) while the scanner initializes. The status LED will stop blinking when initialization is

complete.

Status LED off

Scanner off

Scanner on

Status LED blinks Status LED on

Windows 2000 Professional

A “Digital Signature Not Found” dialog will be displayed the ﬁ rst

time the scanner is connected and turned on following installation

of Nikon Scan. Click Yes to register the scanner with Windows.

If the Status LED Flickers

If the status LED ﬂ ashes quickly (about ﬁ ve times a second), turn the scanner off, wait at least ﬁ ve sec-

onds, and turn the scanner on again. If the problem persists, see “Troubleshooting” (

56).

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 80 81

Pas de commentaire

Nikon 5000 ED Manuel d'utilisateur Page 33