Nikon Coolpix 300 Manuel d'utilisateur télécharger pdf (Page 108)

Troubleshooting : General Problems

Nikon View

displays a “Module has no sources” error when

you attempt to display the camera's data files on your com-

puter

Checklist:

• Is the camera correctly connected to the computer?

Connect the camera to your computer’s serial port or SCSI chain as

described in “Connections.” If you are using an SCSI connection, be

sure that the device number you have chosen for the camera is not the

same as that assigned other SCSI devices, that ON has been chosen as

the camera’s TERMINATOR setting, and that one of the devices in the

chain is providing termination power. If you are using a notebook

computer, check its documentation to determine whether it requires an

additional external terminator at the computer’s end of the SCSI

chain. In the event that you are using a serial connection, check to be

sure that the data transfer rate you have chosen is supported by your

computer, and that the computer’s port settings are “8-bit, no parity,

one stop bit.”

• Is Nikon View properly installed on your computer?

Consult the documentation provided with the software.

1 2 ... 103 104 105 106 107 108 109 110 111 112 113 114 115 116

Pas de commentaire

Nikon Coolpix 300 Manuel d'utilisateur Page 108