Nikon mec-2-fl-d60-n105 Manuel d'utilisateur télécharger pdf (Page 7)

Use of Iris Camera MEC-2-FL-D60-N105 7

13. Note: for general photography, use the enclosed Zoom lens (18-55mm VR) instead (VR=Vibration

Reduction). You may also use any Nikon AF-S or AF-I autofocus lens. Older lenses will not work with

the D60 since it does not include a motor drive; only the newer Nikon AF-S and AF-I lenses have a built-

in motor drive for focusing. You can use any older lens but the auto-focus will not operate.

14. For general photography using the included zoom lens, switch the top Mode dial to AUTO:

15. When you return to iris photography, switch the top Mode dial back to A (A=Aperture Priority).

16. IMPORTANT: Adjust the Eyepiece Dioptric setting. (Initial Setup Only) This is a small slide switch

to the right of the viewfinder that can go up or down through 6 positions (some cameras such as the

D300, have a rotating wheel), and is designed to match the viewfinder optics to your vision. When this is

set: if you see the subject in focus, the camera sees it in focus. If you normally wear corrective lenses,

always wear them when taking a picture. To make this adjustment for your eye:

1. move the switch to one end of the range (top-most or

bottom-most position)

2. look through the viewfinder at a bright surface (such

as a white wall) that is in the distance (this white

surface should appear blurry)

3. while viewing through the viewfinder, move the

switch up or down through the range of 6 positions

until you can see the black bracket marks in the

viewfinder with maximum clarity and focus

4. note the optimal position of this switch for your

vision, and always use this setting. Once you set it fo

your eye’s vision, you do not need to change it. If

someone else uses the camera, they need to find the

correct setting for their vision (and when you resume

using the camera, you need to return this switch to th

setting you found for your vision).

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

Pas de commentaire

Nikon mec-2-fl-d60-n105 Manuel d'utilisateur Page 7